Toyota RAV4 manuals

Toyota Sienna Service Manual: On-vehicle inspection

1. INSPECT CAMSHAFT TIMING CONTROL VALVE ASSEMBLY

 INSPECT CAMSHAFT TIMING CONTROL VALVE ASSEMBLY

  1.  Connect the intelligent tester to the DLC3.
  2.  Turn the ignition switch to the ON position.
  3.  Start the engine and warm it up.
  4.  Select the intelligent tester from the ACTIVE TEST menu.
  5.  Check the engine speed when the OCV (camshaft timing oil control valve) is operated by the intelligent tester.

OK

OK

REMOVAL

1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY

3. DRAIN ENGINE COOLANT

4. REMOVE V-BANK COVER SUB-ASSEMBLY

5. REMOVE NO. 2 AIR CLEANER INLET

6. REMOVE NO. 1 AIR CLEANER INLET

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

9. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

10. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Exhaust Side)

REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

  1.  Disconnect the camshaft timing oil control valve assembly connector.
  2.  Remove the bolt and camshaft timing oil control valve assembly.
  3.  Remove the O-ring from the camshaft timing oil control valve.

11. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Intake Side)

REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

  1.  Disconnect the camshaft timing oil control valve assembly connector.
  2.  Remove the bolt and camshaft timing oil control valve assembly.
  3.  Remove the O-ring from the camshaft timing oil control valve.

12. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Exhaust Side)

  1.  Disconnect the camshaft timing oil control valve assembly connector.
  2.  Remove the bolt and camshaft timing oil control valve assembly.
  3.  Remove the O-ring from the camshaft timing oil control valve.

13. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Intake Side)

REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

  1.  Disconnect the camshaft timing oil control valve assembly connector.
  2.  Remove the bolt and camshaft timing oil control valve assembly.
  3.  Remove the O-ring from the camshaft timing oil control valve.
Components
...

Inspection
1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY  Resistance inspection  Using an ohmmeter, measure the resistance between the terminals. Resistance: 6.9 to 7.9 ] ...

Other materials:

Terminals of ECU
1. CHECK TRANSPONDER KEY AMPLIFIER Disconnect the I14 amplifier connector and measure the resistance between the terminal of the wire harness side connector and body ground. If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnec ...

Solar Sensor Circuit (Driver Side)
DESCRIPTION The solar sensor, which is installed on the upper side of the instrument panel, detects sunlight and controls the air conditioning in AUTO mode. The output voltage from the solar sensor varies according to the amount of sunlight. When the sunlight increases, the output voltage ...

Installation
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL FRONT AIRBAG SENSOR LH  Check that the ignition switch is off.  Check that the battery negative (-) terminal is disconnected. CAUTION: ...

В© 2011-2024 Copyright www.tsienna.net