Toyota Sienna Service Manual: On-vehicle inspection
1. INSPECT THROTTLE BODY
- Listen to the throttle control motor operating sounds.
- Turn the ignition switch to the ON position.
- When pressing the accelerator pedal position
sensor lever, listen to the running motor. Make
sure that no friction noise comes from the
motor.
If friction noise exists, replace the throttle body.
- Inspect the throttle position sensor.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch to the ON position.
- Check that the MIL turns off.
- Under CURRENT DATA, the throttle valve opening percentage (THROTTLE POS) should be within the standard range below.
Standard throttle valve opening percentage: 60% or more If the percentage is less than 60%, replace the throttle body.
NOTICE: When checking the throttle valve opening percentage, the transmission should be in neutral.
Components
...
Removal
1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY
3. DRAIN ENGINE COOLANT
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. REMOVE NO. 2 AIR CLEANER INLET
6. REMOVE ...
Other materials:
System description
1. Radio and navigation assembly outline
Conventionally, 2 separate devices, a "radio and
display" and a "navigation ECU" are used. This
model has adopted a new type, combining these
devices into a single unit.
2. Navigation system outline
Vehicle ...
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for further deta ...
Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit
DESCRIPTION
The curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1167/85 is ...
