Toyota Sienna Service Manual: On-vehicle inspection

Toyota Sienna Service Manual / Supplemental restraint system / Front airbag sensor / On-vehicle inspection

1. INSPECT FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

Perform a diagnostic system check.

2. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

Perform a diagnostic system check.
When the front bumper of the vehicle or its area is damaged, check if there is any damage to the front airbag sensor. If any of the front airbag sensors have defects as mentioned below, replace it with a new one:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling off of the label or damage to the serial number.

CAUTION: Be sure to follow the correct removal and installation procedures.

3. INSPECT FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)

Replace the front airbag sensor.

CAUTION: Be sure to follow the correct removal and installation procedures.

HINT: The front airbag sensor on the impacted side should be replaced after the steering pad or front passenger airbag assembly has deployed.

Removal

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroug ...

Other materials:

Installation
1. INSTALL SEAT MEMORY SWITCH 2. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY LH 3. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH Engage the 4 claws to install the seat me ...

Operation check
NOTICE: Inspection should be started after conforming that the items listed in the "CUSTOMIZE PARAMETER" for the power slide door system have defaulted to the initial settings. 1. CHECK OPENING OPERATION Conditions necessary for the power slide door to open: Power slid ...

Removal
1. Drain automatic transaxle fluid (a) Remove the drain plug, gasket and drain ATF. (b) Install a new gasket and the drain plug. Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 2. Drain transfer oil (for 4wd) Hint: (see page tf-8) 3. Remove front wheel 4. REMOVE FRONT AXLE HUB LH NUT (a) Us ...