Toyota Sienna Service Manual: On-vehicle inspection
1. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE NOT INVOLVED IN COLLISION)
- Perform a diagnostic system check.
2. INSPECT OCCUPANT CLASSIFICATION ECU (VEHICLE INVOLVED IN COLLISION)
- Perform a diagnostic system check.
- Even if the airbag was not deployed, check if there is any damage to the occupant classification ECU. If there are any defects as mentioned below, replace the occupant classification ECU with a new one:
- Cracks, dents or chips on the case.
- Cracks or other damage to the connector.
CAUTION: Be sure to follow the correct removal and installation procedures.
Occupant classification ecu
COMPONENTS
...
Removal
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting th ...
Other materials:
Installation
1. INSTALL THROTTLE BODY
Install a new throttle body gasket to the intake air
surge tank.
Install the throttle body with the 4 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Connect the 2 water by-pass hoses.
Connect the throttle body connector and clamp.
2. ...
Short in Side Squib LH Circuit
DTC B0115/47 Short in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0115/47 is recorded when a short ci ...
Gyro Error
DTC 58-10 Gyro Error
DTC 80-10 Gyro Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the
gyro signal
Gyro sensor
Radio and navigation assembly
80-10
...
