Toyota Sienna Service Manual: On-vehicle inspection
1. CHECK POWER REAR NO. 2 SEAT with STOWING FUNCTION
- Check the basic functions.
- Operate the fold seat switch and power rear No.2 seat switch and check to make sure each seat function works:
- Folding-down operation
- Stowing operation
- Return operation
- Reclining operation
- Park / Neutral Position Switch Circuit
- Back Door Courtesy Switch Circuit
- Indicator Circuit
- Power Source Circuit
- Fold Seat Switch Circuit
- Folding Motor Circuit
- Reclining Motor Circuit
- Release Actuator Circuit
- Lock Switch Circuit
- Rear Power Seat Switch Circuit
- Fold Lock Switch Circuit
Diagnosis system
1. CHECK DLC3
The vehicle uses ISO 15765-4 communication
protocol.
The terminal arrangement of the DLC3 complies
with SAE 1962 and matched the ISO 15765-4
format.
If the resul ...
Park / Neutral Position Switch Circuit
DESCRIPTION
The fold seat control ECU receives signals from the Park/Neutral position
switch and controls the seat
stowing and return operations. If the shift lever is in any position other than
...
Other materials:
Coolant Thermostat (Coolant Temperature Below Thermostat Regulating
Temperature)
HINT:
This DTC relates to the thermostat.
DESCRIPTION
This DTC is set when the Engine Coolant Temperature (ECT) does not reach 75°C
(167°F) despite
sufficient engine warm-up time.
MONITOR DESCRIPTION
The ECM estimates the ECT based on the starting temperature, engine loads,
a ...
Transmission Fluid Temperature Sensor "A"
Performance
DESCRIPTION
The ATF (Automatic Transmission Fluid) temperature sensor converts the fluid
temperature into a
resistance value which is input into the ECM.
MONITOR DESCRIPTION
The ATF temperature sensor converts the ATF temperature to an electrical
resistance value. Based on
the resis ...
Registration Complete Indication Error/ Registration Demand Transmission/
Multiple Frame Incomplete
DTC 01-E0 Registration Complete Indication Error
DTC 01-E3 Registration Demand Transmission
DTC 01-E4 Multiple Frame Incomplete
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
01-E0
"Registration complete" signal from the master device
c ...
