HINT: The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (See page ES-1).
1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch to the ON position.
(c) Select the following menu items: Data List / A/FS B1 S1 and O2S B1 S2.
(d) Warm up the A/F sensor with the engine speed at 2500 rpm for approximately 2 minutes.
(e) Keep the engine speed at 2500 rpm and confirm that the "A/FS B1 S1" and "A/FS BS S1" display is as shown in the illustration.
HINT:
Standard
NOTICE: The A/F sensor has an output delay of a few seconds. |
(f) Confirm that the "O2S B1 S2" and "A/FS BS S1" display changes between 0 to 1 V with the engine speed at 2500 rpm.
OK: The voltage output oscillates more than 8 times in 10 seconds.
NOTICE:
|
On-vehicle inspection
1. INSPECT OCCUPANT CLASSIFICATION ECU
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
2. INSPECT OCCUPANT CLASSIFICATION ECU
(VEHICLE INVOLVED IN COLLISION)
Perform a diagnostic system check.
Even if the airbag was not deployed, check if there ...
Throttle / Pedal Position Sensor / Switch "A/B"
Circuit
DTC P0120 Throttle / Pedal Position Sensor / Switch "A"
Circuit
DTC P0122 Throttle / Pedal Position Sensor / Switch "A"
Circuit Low Input
DTC P0123 Throttle / Pedal Position Sensor / Switch "A"
Circuit High Input
DTC P0220 Throttle / Pedal Position Sensor / Switch ...
Towing with a wheel-lift type truck
From the front (2WD models)
Release the parking brake.
From the front (AWD models)
Use a towing dolly under the rear
wheels.
From the rear
Use a towing dolly under the front
wheels. ...