1. CHECK RADIATOR RESERVOIR CAP SUBASSEMBLY
a) Measure the valve opening pressure.
(1) If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.
(2) Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.
(3) Check that rubber packings 3 and 4 are not stuck together.
(4) Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.
(5) When using the cap tester, tilt it to 30° or more above the horizontal.
(6) Pump the cap tester several times, and check the maximum pressure*.
Pump speed: 1 pump per second
*: Even if the cap cannot maintain the maximum pressure, it is not a defect.
Judgment criterion
If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.
Seat Belt Buckle Switch LH Circuit Malfunction
DTC B0126/27 Seat Belt Buckle Switch LH Circuit Malfunction
DESCRIPTION
The seat belt buckle switch LH circuit consists of the center airbag sensor
assembly and the front seat
inner belt assembly LH.
DTC B0126/27 is recorded when a malfunction is detected in the seat belt buckle
switch LH ...
Disassembly
1. REMOVE RH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
Remove the RH seat rear seat reclining cover by
pulling it out in the arrow mark direction shown in
the illustration.
2. REMOVE LH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
R ...
Driving the vehicle
The following procedures should be observed to ensure safe
driving:
Starting the engine
Driving
With the brake pedal depressed, shift the shift lever to D.
Release the parking brake.
Gradually release the brake pedal and gently depress the accelerator
pedal to accelerate the vehicle.
...