DTC C1249/49 Open in Stop Light Switch Circuit
DESCRIPTION
This skid control ECU inputs the stop light switch signal and detects the status of brake operation.
The skid control ECU has an open detection circuit. If an open in the stop light switch input line or GND side stop light circuit is detected when the stop light switch is off, this DTC is output.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK STOP LIGHT SWITCH OPERATION
(a) Check that the stop light comes on when the brake pedal is depressed, and goes off when the brake pedal is released.
OK: Stop light switch function is normal.
HINT: Check the stop light bulb as it may have burnt out.
2 INSPECT SKID CONTROL ECU (STP TERMINAL VOLTAGE)
(a) Disconnect the skid control ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage
Result
3 RECONFIRM DTC
(a) Clear the DTC (See page BC-10).
(b) Check that the same DTC is recorded (See page BC- 10).
HINT: Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.
Result
REPLACE BRAKE ACTUATOR ASSEMBLY
4 INSPECT STOP LIGHT SWITCH (POWER SOURCE TERMINAL VOLTAGE)
(a) Disconnect the stop light switch connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage
5 INSPECT STOP LIGHT SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance
6 CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND STOP LIGHT SWITCH)
(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT:
REPLACE BRAKE ACTUATOR ASSEMBLY
Location of the spare tire, jack and tools
Spare tire
Jack handle
Tire bag
Jack
Wheel nut wrench
Adapter socket
Tire strap
WARNINGUsing the tire jack
Observe the following precautions.
Improper use of the tire jack may cause the vehicle to suddenly fall off
the jack, leading to death or serious injury. ...
Phone screen
To display the screen shown below, press the
switch on the steering
wheel or the button.
Several functions are available to operate on each screen that is displayed
by selecting the 4 tabs.
Device name
Bluetooth® connection status
Telephone switch
Microphone
The vehicleâ ...
Electronic control
(a) REMOVAL AND INSTALLATION OF BATTERY TERMINAL
REMOVAL AND INSTALLATION OF BATTERY TERMINAL
NOTICE: Certain systems need to be initialized
after
disconnecting and reconnecting the cable from
the negative (-) battery terminal.
(1) Before performing electronic work, disconnect
the ...