Toyota RAV4 manuals

Toyota Sienna 2010-2024 Owners Manual: Operating instructions

Turning the end of the lever turns on the lights as follows: The illustration is intended as an example.

Toyota Sienna. Operating instructions


Toyota Sienna. Operating instructions


  1. The headlights, side marker,
    parking lights, daytime running lights (if equipped) and so on turn on and off automatically (when the engine switch is in the “ON” position [vehicles without a smart key system] or IGNITION ON mode [vehicles with a smart key system]).
  2. The side marker, parking,
    tail, license plate, daytime running lights (if equipped) and instrument panel lights turn on.
  3. The headlights and all
    lights listed above (except daytime running lights) turn on.
  4. Off.


    The daytime running light
    system is off. (Canada)
    The daytime running light
    system is on.

*1: Vehicles without a daytime running light system *2: Vehicles with a daytime running light system

Headlight switch
The headlights can be operated manually or automatically. ...

Turning on the high beam headlights
With the headlights on, push the lever away from you to turn on the high beams. When the light switch is in position, the Automatic High Beam system will be activated. Pull the lev ...

Other materials:

Under hood
GENERAL MAINTENANCE 1. GENERAL NOTES Maintenance requirements very depending on the country. Check the maintenance schedule in the owner's manual supplement. Following the maintenance schedule is mandatory. Determine the appropriate time to service the vehicle using either miles dri ...

Cold Start Idle Air Control System Performance
DTC P050A Cold Start Idle Air Control System Performance DESCRIPTION This monitor will run when the engine is started at -10 to 50C (14 to 122F) of the engine coolant temperature. The DTC will set after the engine idling for 13 seconds (2 trip detection logic). The DTC is designed to monit ...

How to proceed with troubleshooting
1 VEHICLE BROUGHT INTO A WORKSHOP 2 DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION Ask the customer about symptoms and confirm malfunctions. 3 CONFIRM THE SYSTEM NORMAL CONDITION 4 CHECK DTC HINT: If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal ...

© 2011-2024 Copyright www.tsienna.net