1. DETECTION RANGE MEASUREMENT AND INDICATOR CHECK
NOTICE: Apply the parking brake securely so that the vehicle does not move.
NOTICE: The measured detection range is for the φ60 mm (2.36 in.) pole. The detection range for walls and other obstacle is different.
Operation condition
HINT: Since sound waves are used for the detection range measurement, the detection range may vary a little due to the outside air temperature.
Operation condition
HINT: Since sound waves are used for the detection range measurement, the detection range may vary a little due to the outside air temperature
Operation condition
HINT: Since sound waves are used for the detection range measurement, the detection ranges may vary a little due to the outside air temperature.
2. CHECK INITIAL CHECK FUNCTION
Turn the ignition switch and clearance main switch ON. The LED are buzzer will operate for about 1 second +- 0.3 seconds, regardless of shift lever position or vehicle speed. The system will then begin normal detection operation.
If the LED or buzzer is faulty, the relevant LED and buzzer operate as shown in the illustration below.
HINT:
For vehicles with 4 sensors:
For vehicles with 6 sensors:
If the sensor is found to have an anomaly due to an open circuit or freezing for approximately 5 seconds or more, indications as shown in the following illustration appear.
HINT:
Distance Control Switch Circuit
DESCRIPTION
The distance control switch sets the vehicle-to-vehicle distance mode. The
distance control switch is
installed in the steering pad switch. The vehicle-to-vehicle distance set value
can be changed by
operating the steering pad switch (distance control switch) while the dynamic
l ...
Repair
1. REPAIR REAR WINDOW DEFOGGER WIRE
Clean the broken wire tips with grease, wax and
silicone remover.
Place the masking tape along the both sides of the
wire.
Thoroughly mix the repair agent (Dupont paste No.
4817).
Using a fine tip brush, apply a smal ...
Inspection
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
LO Operation Check
Connect the battery (+) to the terminal 1 (+1) of
the connector, the battery (-) to the terminal 5
(E) of the connector, and check that the motor
operates at low speed (LO).
HI Operation Check
...