Toyota Sienna Service Manual: Outer mirror switch
Inspection
1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/o Memory)
- The L side of the left / right adjustment switch: Inspect the mirror switch resistance.
Standard resistance (Left side)
If the result is not as specified, replace the switch assembly.
- The R side of the left / right adjustment switch: Inspect the mirror switch resistance.
Standard resistance (Right side)
If the result is not as specified, replace the switch assembly.
2. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/ Memory)
- Remove the outer mirror control switch.
- Measure the resistance according to the value(s) in the table below when the switch is operated.
Resistance
*1: The L or R of the left / right adjustment switch.
Installation
1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
Install the mirror with the 3 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
Connect the connector.
...
Instrument panel
...
Other materials:
Distance Control Switch Circuit
DESCRIPTION
The distance control switch sets the vehicle-to-vehicle distance mode. The
distance control switch is
installed in the steering pad switch. The vehicle-to-vehicle distance set value
can be changed by
operating the steering pad switch (distance control switch) while the dynamic
l ...
Network gateway ECU
COMPONENTS
REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE LH
2. REMOVE COWL SIDE TRIM BOARD LH
3. REMOVE INSTRUMENT PANEL FINISH PANEL
LOWER LH (See page IP-6)
4. REMOVE INSTRUMENT PANEL SAFETY PAD
INSERT NO. 1 (See page IP-6)
5. REMOVE CLEARANCE WARNING ECU ASSEMBLY
(See page PM-15)
6. REMOVE ...
Power slide door warning buzzer
INSPECTION
1. INSPECT POWER SLIDE DOOR WARNING BUZZER LH
Check the resistance of the buzzer.
Resistance
If the result is not as specified, replace the buzzer.
NOTICE:
The circuit that causes the buzzer to sound is
built into the slide door ECU, not around the
buzzer.
Direct ...
