Toyota Sienna Service Manual: Outer rear view mirror

Inner rear view mirror

COMPONENTS REMOVAL 1. REMOVE INNER REAR VIEW MIRROR ASSEMBLY  w/ EC mirror: Remove the inner rear view mirror cover.  w/ EC mirror: Disconnect the connector.  Remove ...

Removal

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE FRONT DOOR SERVICE HOLE COVER LH  Remove the front lower frame bracket garnish LH.  Remove the front door i ...

Other materials:

No Master/ Connection Check Error
DTC 01-D6 No Master DTC 01-D7 Connection Check Error DESCRIPTION HINT:  *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.  *2: When 210 seconds have elapsed after disconnecting the power supply ...

Disassembly
HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH Using a screwdriver, disengage the clip and claw, and remove the garnish. HINT: Tape the screwdriver tip before use. 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH ...

Terminals of ECU
1. TELEVISION CAMERA ASSEMBLY  Disconnect the T10 camera connector Measure the voltage and resistance of each terminal of the wire harness side connector. If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnect the T10 ...