Toyota Sienna Service Manual: Outside moulding

Installation

1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasolin ...

Removal

1. REMOVE OUTSIDE MOULDING Put protective tape around the outside moulding. Using a heat light, heat the moulding between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the moulding ex ...

Other materials:

Installation
1. INSTALL SPARK PLUG (a) Install the 6 spark plugs. Torque: 18 N*m (183 kgf*cm, 13 ft.*lbf) 2. INSTALL IGNITION COIL ASSEMBLY (a) Install the 6 ignition coils with the 6 bolts. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) (b) Connect the 6 ignition coil connectors. 3. INSTALL NO. 1 SUR ...

Installation
1. INSTALL SEAT POSITION AIRBAG SENSOR  Check that the ignition switch is off.  Check that the negative battery (-) terminal is disconnected. CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.   ...

Passenger Side Outer Mirror ECU
DTC B1208 Passenger Side Outer Mirror ECU DESCRIPTION This DTC is detected when communication between the outer mirror control ECU RH and multiplex network gateway ECU stops for more than 10 seconds. DTC No. DTC Detecting Condition Trouble Area B1208 Pa ...