Toyota RAV4 manuals

Toyota Sienna Service Manual: Personal light assembly

Toyota Sienna Service Manual / Lighting / Personal light assembly

ON-VEHICLE INSPECTION

1. ROOF CONSOLE BOX ASSEMBLY

ROOF CONSOLE BOX ASSEMBLY

  1.  Inspect map light assembly resistance.
  1.  Check the resistance between the terminals at each switch position as shown in the chart.

Resistance

Resistance

High mounted stop light assembly
COMPONENTS REMOVAL 1. REMOVE BACK DOOR GARNISH CENTER (w/ Rear Spoiler) 2. REMOVE REAR SPOILER COVER (w/ Rear Spoiler) 3. REMOVE CENTER STOP LIGHT ASSEMBLY  w/o Rear spoiler: ...

Room light assembly
ON-VEHICLE INSPECTION 1. ROOM LIGHT ASSEMBLY NO.2  Check that the resistance exists between the terminals. Resistance: Below 1 Ω 2. INTERIOR DOME LIGHT SWITCH ASSEMBLY   ...

Other materials:

Operating the HomeLink
Press the appropriate HomeLink® button. The HomeLink® indicator light on the HomeLink® transceiver should turn on. The HomeLink® continues to send a signal for up to 20 seconds as long as the button is pressed. Reprogramming a HomeLink® button Press and hold the desired HomeLink® button ...

DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER) Checking DTCs. Connect the intelligent tester to the DLC3. Turn the ignition switch ON. Read DTCs by following the prompts on the tester screen. HINT: Refer to the intelligent tester operator's manual for further details. 2. CLEAR DTC ...

Wiper switch
COMPONENTS REMOVAL 1. REMOVE STEERING COLUMN COVER 2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY  Disconnect the connector.  Using a screwdriver, disengage the claw and pull out the windshield wiper switch assembly. NOTICE: The claw will be broken if pressed hard. HINT ...

© 2011-2024 Copyright www.tsienna.net