DESCRIPTION
* The shift lever is moved into any position except P position.
* The back door is open or the power back door is activated to open.
The warning buzzer continues to sound until the back door is fully closed or the shift lever is moved into the P position.
HINT:
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
HINT: During the ACTIVE TEST, the intelligent tester sends a signal to the power back door ECU to drive the warning buzzer. If the warning buzzer operates, the warning buzzer itself and the wire harness between the warning buzzer and power back ECU are considered to be functioning normally.
OK (Power slide door ECU):
2 CHECK WIRE HARNESS (POWER BACK DOOR WARNING BUZZER WIRE HARNESS SIDE)
NOTICE: Use an oscilloscope to check the output voltages of the buzzer.
Voltage
3 INSPECT POWER BACK DOOR WARNING BUZZER
Resistance
NOTICE:
4 CHECK WIRE HARNESS (POWER BACK DOOR WARNING BUZZER - POWER BACK DOOR ECU)
Resistance (Check for open circuit)
REPLACE POWER BACK DOOR ECU
Installation
1. INSTALL THROTTLE BODY
(a) Install a new throttle body gasket to the intake air
surge tank.
(b) Install the throttle body with the 4 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
(c) Connect the 2 water by-pass hoses.
(d) Connect the throttle body connector and clamp.
2. INSTA ...
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The stereo jack adapter sends an external device sound signal to the radio
receiver through this circuit.
The sound signal that has been sent is amplified by the stereo component
amplifier or radio receiver, and
then is sent to the speakers.
If there is an open or short in th ...
For vehicles equipped with vehicle stability control (vsc) system
(a) Notices when using drum tester
Notices when using drum tester.
(1) When using a drum tester, be sure to start the
engine with the ignition switch OFF, and connect
SST to the terminals TS and CG of the DLC3
before the measurement in order to cancel the
VSC operation.
SST 09843-18040
...