Toyota RAV4 manuals

Toyota Sienna Service Manual: Power Seat ECU Communication Stop

DTC B1272 Power Seat ECU Communication Stop

DESCRIPTION

This DTC is detected when communication between the seat position control ECU and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.

DTC Detection Condition

Trouble Area

B1272

Power seat ECU communication stops
  • Seat position control ECU
  • Wire harness

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - BATTERY)

CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - BATTERY)

  1. Disconnect the P58 and P59 ECU connectors.
  2. Measure the voltage according to the value(s) in the table below.

Standard voltage

Standard voltage

2 CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - GROUND)

CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - GROUND)

  1. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

3 CHECK COMMUNICATION LINE

CHECK COMMUNICATION LINE

  1. Disconnect the G4 ECU connector.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

Result

Result

REPLACE SEAT POSITION CONTROL ECU

Combination Meter ECU Communication Stop
DTC B1271 Combination Meter ECU Communication Stop DESCRIPTION DTC B1271 is output when communication between the combination meter and the multiplex network gateway ECU stops for more than 10 se ...

Airbag ECU Communication Stop
DTC B1281 Airbag ECU Communication Stop DESCRIPTION DTC B1281 is output when communication between the airbag ECU and the multiplex network gateway ECU stops for more than 10 seconds. ...

Other materials:

Trip information
Type A Press the “CAR” button. Type B Press the “APPS” button, and then select “Eco” on the screen. If the “Past Record” screen is displayed, select “Trip Information”. Reset the trip information data Previous fuel consumption per minute Current fuel ...

Installation
1. INSTALL SHOCK ABSORBER ASSEMBLY REAR LH (a) Install the rear spring bumper No.1 LH to the shock absorber assembly LH. (b) Support the rear axle beam assembly with a jack. (c) Install the rear shock absorber assembly rear LH, cushion retainer and nut to the rear axle beam. (d) ...

VIN not Programmed or Mismatch - ECM / PCM
DESCRIPTION DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN with the intelligent tester. MONITOR STRATEGY TYPICAL ENABLING CONDITIONS TYPICAL MALFUNCTION THRESHOLDS ...

© 2011-2024 Copyright www.tsienna.net