DESCRIPTION
When the power seat control switch is operated, a command signal is sent to the position control ECU and switch assembly (power seat control switch and ECU). The front power seat switch then controls the appropriate seat motor as needed. This memory system does not use a seat position sensor. The seat position is detected by counting pulses that are output when the motor turns. If there is no pulse output from the motor, the motor will stop operating. The position control ECU and switch assembly (power seat control switch and ECU) is designed so that any malfunction of the seat memory system will not interfere with manual seat control.
If the position control ECU and switch assembly (power seat control switch and ECU) detects a low motor speed, abnormal activity, or sudden motor current fluctuation, the system will stop the motor. If the motor operates continuously for 120 seconds or more, the system will stop the motor until the switch is turned on again.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK FRONT POWER SEAT OPERATION
Result
2 READ VALUE OF INTELLIGENT TESTER (FRONT POWER SEAT SWITCH)
Position control ECU & switch assembly LH, RH
OK: On tester screen, each item changes between ON and OFF according to above chart.
3 PERFORM ACTIVE TEST BY ACTIVE TEST USING INTELLIGENT TESTER (POWER SEAT MOTOR)
Position control ECU & switch assembly (driver, passenger side)
OK: The power seat motors operate normally.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
4 INSPECT FRONT SEAT ADJUSTER SUB-ASSEMBLY (POWER SEAT MOTOR)
OK: The power seat motor operates.
5 CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH ASSEMBLY - POWER SEAT MOTOR)
Standard resistance
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
6 CHECK WIRE HARNESS (POWER SEAT CONTROL SWITCH - BATTERY AND BODY GROUND)
Standard voltage (Driver side)
Standard resistance (Driver side)
7 INSPECT POWER SEAT CONTROL SWITCH (LUMBER SUPPORT CONTROL)
8 INSPECT FRONT SEAT ADJUSTER SUB-ASSEMBLY (POWER SEAT MOTOR)
OK: The power seat motor operates
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SEAT CONTROL SWITCH - POWER SEAT MOTOR)
Towing related terms
GCWR (Gross Combination Weight Rating)
The maximum allowable gross
combination weight. The gross
combination weight is the sum
of the total vehicle weight
(including the occupants, cargo
and any optional equipment
installed on the vehicle) and the
weight of the trailer being towed
(incl ...
Washer fluid
If any washer does not work or the
warning message appears on the
multi-information display, the
washer tank may be empty. Add
washer fluid.
WARNINGWhen refilling washer fluid
Do not refill washer fluid when the engine is hot or running, as
washer fluid
contains alcohol and ...
Lost Communication with Steering Angle Sensor
Module
DTC U0126 Lost Communication with Steering Angle Sensor
Module
DESCRIPTION
This circuit detects the angle and direction of the steering wheel and
automatically transmits a signal to
the skid control ECU and distance control ECU.
DTC No.
DTC Detection Condition
Trouble ...