Toyota Sienna Service Manual: Power slide door

Power slide door control motor and clutch

INSPECTION 1. INSPECT SLIDE DOOR CONTROL MOTOR AND CLUTCH ASSEMBLY LH Remove the motor and clutch. Connect the battery positive (+) lead to terminal 3 and the battery negative (-) lead to ...

Removal

HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE SLIDE DOOR Remove the rear door scuff plate (See page IR-7). Remove the back door scuff plate (See page ED- 214 ...

Other materials:

Removal
1. REMOVE REAR WHEEL 2. REMOVE REAR SHOCK ABSORBER CAP LH (a) Remove the shock absorber head cover. (b) Remove the shock absorber cap LH. 3. REMOVE SHOCK ABSORBER ASSEMBLY REAR LH (a) Support the rear axle beam with a jack. (b) Using a 6 mm hexagon wrench to hold the piston rod, ...

Seat Position Airbag Sensor Circuit Malfunction
DTC B1153/25 Seat Position Airbag Sensor Circuit Malfunction DESCRIPTION The seat position airbag sensor circuit consists of the center airbag sensor assembly and the seat position airbag sensor. DTC B1153/25 is recorded when a malfunction is detected in the seat position airbag sensor cir ...

Rear Occupant Classification Sensor LH Collision Detection
DTC B1787 Rear Occupant Classification Sensor LH Collision Detection DESCRIPTION DTC B1787 is output when the occupant classification ECU receives a collision detection signal sent by the rear occupant classification sensor LH if an accident occurs. DTC B1787 is also output when the front s ...