DESCRIPTION
This is caused by the jam protection function between the slide door and vehicle body. A cable connects the rear power window regulator and the slide door half-open stopper directly. When the rear power window regulator operates until the opening reaches 150 mm (5.91 in.) or more, the rear power window regulator transmits a signal to the half-open stopper through the cable and then the stop lever is activated. This prevents the slide door from opening fully.
* OFF is the position where the orange paint on the top of the switch does not appear
INSPECTION PROCEDURE
1 CHECK REAR WINDOW POSITION
2 VISUALLY CHECK
3 CHECK OPERATION
CHECK FOR DTC AND INSPECT POWER SLIDE DOOR SYSTEM
On-vehicle inspection
1. CHECK POWER SEAT FUNCTION
Check the basic functions.
Operate the power seat switches and check the
following seat functions:
Sliding
Reclining
Front vertical (Driver side seat only)
Lifter (Driver side seat only)
Lumbar suppo ...
Abbreviations used in manual
...
Problem symptoms table
HINT:
Use the table below to help determine the cause of the
problem symptom. The likely causes of the problem are
indicated in descending order. Check each suspected area
in order. Repair or replace faulty parts or perform
adjustments as necessary.
Inspect the fuse and rel ...