Toyota Sienna Service Manual: Power Slide Door LH does not Operate When Satellite Switch is Pressed
DESCRIPTION
- The power slide door operates only when the power slide door main switch is ON (switch free: orange paint on the top of the switch appears). The power slide door ECU LH controls the power slide door LH, which activates the slide door motor to open / close the slide door.
- A request signal from the satellite switch for the power slide door LH is input to the the driver side junction block ECU, which then sends this request signal using a BEAN line to the power slide door ECU LH.
- A request signal from the power slide door control switch LH is directly input to the power slide door ECU LH.
- When the child lock is in the locked condition, the power slide door control switch LH is disabled, thus the power slide door LH is not activated by this switch.
- When the fuel lid is open, the power slide door does not operate. Opening the fuel lid while the power slide door is operating stops the power slide door operation and switches the system to manual operation mode.
- When the touch sensor has an open / short-circuit, closing of the power slide door is disabled.
NOTICE: When disconnecting the negative (-) terminal cable of the battery or control motor and clutch, initialize the power slide door system
WIRING DIAGRAM
Power Slide Door Pulse Sensor Malfunction on
Rear Left Door
DTC B2224 Power Slide Door Pulse Sensor Malfunction on
Rear Left Door
DESCRIPTION
A pulse sensor is built into slide door LH for jam and foreign
object detection and for slide door posi ...
Inspection procedure
1 BASIC INSPECTION
Check the conditions necessary for the power slide door
to open:
Power slide door main switch is in the ON position
(switch free: orange paint on the top of the ...
Other materials:
Manual Up / Down and Auto Down Function does not Operate on
Passenger Side Only
DESCRIPTION
If the manual UP/DOWN function does not operate, the power window motor, the
regulator switch or the
wire harness may be malfunctioning.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK WIRE HARNESS (POWER SOURCE)
Disconnect the P37 regulator switch connector.
Turn ...
Disposal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When scrapping a vehicle equipped with the SRS or
disposing of the front seat side airbag assembly, be sure to
deploy the airbag first in accordance with the proc ...
Customer problem analysis
HINT:
In troubleshooting, confirm that the problem symptoms
have been accurately identified. Preconceptions should be
discarded in order to make an accurate judgment. To
clearly understand what the problem symptoms are, it is
extremely important to ask the customer about the
problem an ...
