DESCRIPTION
NOTICE: When disconnecting the negative (-) terminal cable of the battery or control motor and clutch, initialize the power slide door system
WIRING DIAGRAM
Installation
1. INSTALL BRAKE MASTER CYLINDER
(a) Install the brake master cylinder with the 2 nuts.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
(b) Slide the clip and connect the brake master cylinder
reservoir hose.
(c) Using SST, connect the 2 brake tube to the brake
master cylinder.
SST 09023-001 ...
Removal
1. REMOVE FRONT WHEELS
2. REMOVE ENGINE UNDER COVER NO.1
3. DRAIN AUTOMATIC TRANSAXLE FLUID
(a) Remove the drain plug, gasket and drain ATF.
(b) Install a new gasket and the drain plug.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
4. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
HINT:
(See page DS-6)
...
Initialization
1. RESET
When the battery is reconnected:
The back door is locked and therefore cannot be
opened. Therefore, it is necessary to unlock the
back door using the door control switch or
transmitter switch.
Reset the power back door system:
The power back door ECU records the ...