Toyota Sienna Service Manual: Power slide door warning buzzer
INSPECTION
1. INSPECT POWER SLIDE DOOR WARNING BUZZER LH
- Check the resistance of the buzzer.
Resistance
If the result is not as specified, replace the buzzer.
NOTICE:
- The circuit that causes the buzzer to sound is built into the slide door ECU, not around the buzzer.
- Directly applying battery voltage to the buzzer does not cause the buzzer to sound.
2. INSPECT POWER SLIDE DOOR WARNING BUZZER RH
- Check the resistance of the buzzer.
Resistance
NOTICE:
- The circuit that causes the buzzer to sound is built into the slide door ECU, not around the buzzer.
- Directly applying battery voltage to the buzzer does not cause the buzzer to sound.
If the result is not as specified, replace the buzzer.
Slide door half open stopper control assembly
INSPECTION
1. INSPECT SLIDE DOOR HALF OPEN STOPPER CONTROL ASSEMBLY
Inspect the resistance of the switch.
Resistance
If the result is not as specified, replace the control
sub-assembly ...
Back door
COMPONENTS
...
Other materials:
Short to GND in Rear Curtain Shield Squib RH
Circuit
DTC B1632/81 Short to GND in Rear Curtain Shield Squib RH
Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC ...
Brake Warning Light Remains ON
DESCRIPTION
If the ECU detects a trouble, it turns on the brake warning light at the same
time of prohibiting ABS
control.
At this time, the ECU records a DTC in memory.
Connect terminals TC and CG of the DLC3 to make the brake warning light blink
and output the DTC.
WIRING DIAGRAM
...
If you think something is
wrong
If you notice any of the following symptoms, your vehicle probably
needs adjustment or repair. Contact your Toyota dealer as
soon as possible.
Visible symptoms
Fluid leaks under the vehicle
(Water dripping from the air conditioning after use is normal.)
Flat-looking tires or uneven tire w ...
