DESCRIPTION
* The ignition switch is turned ON.
* The shift lever is moved into any position except P position.
* The slide door is open or the power slide door is activated to open.
The warning buzzer continues to sound until the slide door is fully closed or the shift lever is moved into the P position.
HINT:
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
HINT: During the ACTIVE TEST, the intelligent tester sends a signal to the power slide door ECU LH to activate the warning buzzer. If the warning buzzer is activated, the warning buzzer itself and the wire harness between the warning buzzer and power slide door ECU LH are considered to be functioning normally
OK (Power slide door ECU LH):
2 CHECK WIRE HARNESS (POWER SLIDE DOOR WARNING BUZZER LH - BODY GROUND)
NOTICE: Use an oscilloscope to check the output voltages of the buzzer.
Voltage
3 INSPECT POWER SLIDE DOOR WARNING BUZZER LH
Resistance
NOTICE:
4 CHECK WIRE HARNESS (POWER SLIDE DOOR WARNING BUZZER LH - POWER SLIDE DOOR ECU LH)
Resistance (Check for open circuit)
REPLACE POWER SLIDE DOOR ECU LH
Engine Coolant Temperature Circuit
DESCRIPTION
A thermistor is built into the Engine Coolant Temperature (ECT) sensor, of
which the resistance value
varies according to the ECT.
The structure of the sensor and its connection to the ECM are the same as those
of the Intake Air
Temperature (IAT) sensor.
HINT:
When any ...
Safety information for Safety Connect
Important! Read this information before using Safety Connect.
Exposure to radio frequency signals
The Safety Connect system installed in your vehicle is a low-power
radio transmitter and receiver. It receives and also sends out radio
frequency (RF) signals.
In August 1996, the Federal Communi ...
Adjustment
HINT:
On the RH side, use the same procedures as on the LH side.
1. INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH
Check that the clearance is within the standard
range.
Standard
2. ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH
Using the SST, horizontally and vertically adjust the
...