DESCRIPTION
* The ignition switch is turned ON.
* The shift lever is moved into any position except P position.
* The slide door is open or the power slide door is activated to open.
The warning buzzer continues to sound until the slide door is fully closed or the shift lever is moved into the P position.
HINT:
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER
HINT: During the ACTIVE TEST, the intelligent tester sends a signal to the power slide door ECU RH to activate the warning buzzer. If the warning buzzer is activated, the warning buzzer itself and the wire harness between the warning buzzer and power slide door ECU RH are considered to be functioning normally.
OK (Power slide door ECU RH):
2 CHECK WIRE HARNESS (POWER SLIDE DOOR WARNING BUZZER RH - BODY GROUND)
NOTICE: Use an oscilloscope to check the output voltages of the buzzer
Voltage
3 INSPECT POWER SLIDE DOOR WARNING BUZZER RH
Resistance
NOTICE:
4 CHECK WIRE HARNESS (POWER SLIDE DOOR WARNING BUZZER RH - POWER SLIDE DOOR ECU RH)
Resistance (Check for open circuit)
REPLACE POWER SLIDE DOOR ECU RH
Air Intake Control Circuit
DESCRIPTION
The air cleaner is equipped with two inlets, one of which is opened or closed
by the Air Intake Control
Valve (AICV). This system reduces intake noise and increases engine power at
low-to-high engine speed
range.
When the engine is operating in the low-to-mid speed range, this ...
Open in Front Passenger Side Squib Circuit
DTC B0106/54 Open in Front Passenger Side Squib Circuit
DESCRIPTION
The front passenger side squib circuit consists of the center airbag sensor
assembly and the front
passenger airbag assembly.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0106/54 is rec ...
Removal and installation of engine intake parts
REMOVAL AND INSTALLATION OF ENGINE INTAKE PARTS
(a) If any metal particles enter inlet system parts, this
may damage the engine.
(b) When removing and installing inlet system parts,
cover the openings of the removed parts and engine
openings. Use gummed tape or other suitable
materials ...