DESCRIPTION
If all of the door windows do not operate, no power may be supplied to the power window master switch or the power window master switch itself may have a malfunction.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (PWR, ECU-IG, AM1)
Standard resistance: Below 1 Ω
2 INSPECT RELAY (IG1, PWR)
Standard resistance
3 CHECK WIRE HARNESS (TO DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
Standard voltage
Standard resistance
4 CHECK WIRE HARNESS (TO POWER WINDOW REGULATOR MASTER SWITCH)
Standard voltage
Standard resistance
5 CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - POWER WINDOW MASTER SWITCH)
Standard resistance
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
Vehicle Speed Sensor "A"
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ECU.
The skid control ECU converts these wheel speed signals into a 4-pulse signal
and outputs it to the ECM
via the combination meter. The ECM determines the vehicle speed based o ...
Power Back Door does not Operate
DESCRIPTION
The power back door operates only when the power back door main
switch is ON. The power back
door ECU controls the power back door by activating the back door motor
(built into the power back
door drive unit) to open / close the back door.
A request signal from the satell ...
Installation
1. INSTALL SPIRAL CABLE
Check that the front wheels are facing straight
ahead.
Set the turn signal switch to the neutral position.
NOTICE:
If it is not in the neutral position, the pin of the
turn signal switch may snap.
Install the spiral cable.
NOTICE:
When ...