1. Before operating the power rear no. 2 seat with stowing function, make sure that there is nothing in the path of the seat.
CAUTION: If someone or something is caught between the seat and other parts, injury or damage may result.
2. Before operating the power rear no. 2 seat with stowing function, make sure that there is nothing on the seat.
HINT: If the system detects that an object is caught in the seat when the folding switch is operated, operating the stowing switch right after the detection will not cause the seat to move.
PARTS LOCATION
SYSTEM DIAGRAM
Disassembly
1. REMOVE RH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
Remove the RH seat rear seat reclining cover by
pulling it out in the arrow mark direction shown in
the illustration.
2. REMOVE LH SEAT REAR SEAT RECLINING COVER
Remove the 2 screws.
R ...
On-vehicle inspection
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT
INVOLVED IN COLLISION)
Perform a diagnostic system check.
2. INSPECT SEAT POSITION SENSOR (VEHICLE
INVOLVED IN COLLISION)
Perform a diagnostic system check.
Even if the airbag was not deployed, check if there
is any dama ...
TRAC OFF Indicator Light does not Come ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN and
multiplex communications.
When the traction OFF switch is turned on, the TRAC OFF indicator light will
come on (for 2WD model).
WIRING DIAGRAM
Refer to TRAC OFF Indicator Light Remains ON (See page BC-157).
...