Toyota Sienna Service Manual: Problem symptoms table
HINT: Proceed to the troubleshooting for each circuit in the table below.
AIRBAG SYSTEM
|
Symptom |
Suspected Area |
| The SRS warning light goes off after the primary check, but then comes on. | SRS Warning Light Remains ON |
| When the ignition switch is turned to the ON position, the SRS warning light sometimes remains on even after approximately 6 seconds. | SRS Warning Light Remains ON |
| The SRS warning light always comes on even when no DTC is output. | SRS Warning Light Remains ON |
| When the ignition switch is turned to the ON position, the SRS warning light does not come on. | SRS Warning Light does not Come ON |
| Although the SRS warning light operates normally, a DTC or a normal system code is not displayed. | Diagnosis Circuit |
| Although terminals TC and CG are not connected, a DTC or normal system code is displayed. | Diagnosis Circuit |
How to proceed with
troubleshooting
HINT:
*: Use the intelligent tester.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
(a) Confirm problem symptoms
3 CHECK MULTIPLEX COMMUNICATION SYSTEM*
Check if the multi ...
Terminals of ECU
1. CENTER AIRBAG SENSOR ASSEMBLY (w/ Side
Airbag)
2. CENTER AIRBAG SENSOR ASSEMBLY (w/o Side
Airbag)
...
Other materials:
High mounted stop light assembly
COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER (w/ Rear Spoiler)
2. REMOVE REAR SPOILER COVER (w/ Rear Spoiler)
3. REMOVE CENTER STOP LIGHT ASSEMBLY
w/o Rear spoiler:
Disconnect the connector and remove the 2
screws and the center stop light assembly.
...
Air outlets
Location of air outlets
The air outlets and air volume
changes according to the
selected air flow mode.
Adjusting the position of and opening and closing the air outlets
Center outlets
Right and left side outlets
Turn the knob to open or close the vent.
Direct air f ...
Cranking Holding Function Circuit
DESCRIPTION
The system detects the ignition switch's starting signal (STSW) and then
supplies current to the starter
until the ECM judges that the engine has started successfully. The purpose is to
reduce the holding time
of the ignition key.
WIRING DIAGRAM
Refer to DTC P0617.
INSPECTI ...
