Toyota Sienna Service Manual: Problem symptoms table
HINT: Proceed to troubleshooting of each circuit in the table below.
1. HEADLIGHT AND TAIL LIGHT SYSTEM
2. AUTOMATIC LIGHT CONTROL SYSTEM
3. LIGHT AUTO TURN OFF SYSTEM
4. FOG LIGHT SYSTEM
5. TURN SIGNAL AND HAZARD WARNING SYSTEM
6. ILLUMINATED ENTRY SYSTEM
7. OTHERS
Operation check
1. ILLUMINATED ENTRY SYSTEM OPERATION CHECK
The illuminated entry system is explained below:
Turn the ignition switch OFF, close all the doors,
and set them in the lock conditi ...
Terminals of ECU
1. Instrument Panel Junction Block Assembly
...
Other materials:
Throttle / Pedal Position Sensor
HINT:
These DTCs relate to the Accelerator Pedal Position (APP) sensor.
DESCRIPTION
HINT:
This ETCS (Electronic Throttle Control System) does not use a throttle cable.
The Accelerator Pedal Position (APP) sensor is integrated with the accelerator
pedal bracket and has 2
sensor circuits ...
Removal
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY
HINT:
Refer to the instructions for removal of the instrument
panel sub-assembly w/ passenger airbag assembly (See
page IP-5).
2. REMOVE HEATER TO FOOT DUCT NO.1
(a) Remove the clip and the heater to foot duct No. 1.
3 ...
On-vehicle inspection
1. INSPECT FRONT AXLE HUB BEARING BACKLASH
(a) Using a dial gauge, check for backlash near the
center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
If backlash exceeds the maximum, replace the
bearing.
NOTICE:
Ensure that the dial gauge is set at right angles
to the measurement surface ...
