Toyota RAV4 manuals

Toyota Sienna Service Manual: Problem symptoms table

POWER WINDOW CONTROL SYSTEM (W/ JAM PROTECTION)

Symptom

Suspected Area

AUTO UP/DOWN function does not operate
  1. Power window regulator motor assembly (Driver side)
  2. Wire harness
  3.  Power window regulator master switch assembly
Remote UP/DOWN function does not operate
  1. Power window regulator motor assembly (Driver side)
  2. Power window regulator master switch assembly
  3. Wire harness
Manual UP/DOWN function does not operate on driver side
  1. P/W fuse
  2. Power window regulator master switch assembly
  3. Power window regulator motor assembly (Driver side)
  4. Wire harness
Manual UP/DOWN function does not operate on passenger side only
  1. Power window regulator switch assembly (Passenger side)
  2. Power window regulator motor assembly (Passenger side)
  3.  Wire harness
Manual UP/DOWN function does not operate on rear LH only
  1. Power window regulator switch assembly rear (Rear LH)
  2. Power window regulator motor assembly LH (Rear LH)
  3. Wire harness
Manual UP/DOWN function does not operate on rear RH only
  1. Power window regulator switch assembly rear (Rear RH)
  2. Power window regulator motor assembly RH (Rear RH)
  3. Wire harness
Power windows do not operate at all
  1. PWR fuse
  2. ECU-IG fuse
  3. P/W relay
  4. IG1 relay
  5. Power window regulator master switch assembly
  6. Wire harness
  7. Driver side J/B assembly (Multiplex network body ECU)
Power window can be operated after ignition switch is turned OFF even if operative conditions are not met
  1. Front door courtesy lamp switch
  2. Wire harness
  3. Driver side J/B assembly (Multiplex network body ECU)
AUTO UP operation does not fully close power window (Jam protection function is activated)
  1. Front door glass run LH
  2. Front door window glass LH
  3. Front door window regulator sub-assembly LH
Power window can be operated by wireless operation Driver side J/B assembly (Multiplex network body ECU)
Initialization
NOTICE:  Resetting the power window motor (initializing the pulse sensor) is necessary when the battery terminal is disconnected; when the master switch, wire harness, power window regu ...

Diagnosis system
1. CHECK DLC3  The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. N ...

Other materials:

Cooling fan relay
On-vehicle inspection 1. Cooling fan relay (a) Remove the relay from engine room relay block No. 1. (b) Measure the resistance of the relay. Standard resistance If the result is not as specified, replace the cooling fan relay. (c) Install the relay to engine room relay block No. ...

Master Error
DTC 01-DF Master Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 01-DF *1 The device with a display fails and the master is switched to the audio device. Also when a communication error between sub-master (audio) and master occu ...

Inspection
1. INSPECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) (a) Measure the resistance of the sensor. Standard resistance If the resistance is not as specified, replace the sensor. 2. INSPECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) (a) Measure the resistance of the sensor. Standard r ...

В© 2011-2024 Copyright www.tsienna.net