Toyota Sienna Service Manual: Problem symptoms table
SLIDE DOOR CLOSER SYSTEM
|
Symptom |
Suspected Area |
| Slide door closer LH does not operate (*1) |
|
| Slide door closer RH does not operate |
|
| Slide door closer LH does not operate (*2) |
|
HINT:
- *1: with Power Slide Door
- *2: without Power Slide Door
Initialization
1. RESET
Reset the power slide door system:
The power slide door ECU records the fully open
position of the power slide door in its memory and
the power slide door fully opens and clos ...
Terminals of ECU
1. CHECK POWER SLIDE DOOR ECU LH (WITH
POWER SLIDE DOOR)
Disconnect the P25 and P26 ECU connectors, and
check the voltage and resistance of each terminal of
the wire harness side connecto ...
Other materials:
Cold Start Ignition Timing Performance
DESCRIPTION
This monitor will run when the engine is started at -10 to 50°C (14 to 122°F)
of the engine coolant
temperature. The DTC will set after the engine idling for 13 seconds (2 trip
detection logic).
The DTC is designed to monitor the idle air control at cold start. When the
...
Circuit opening relay
Inspection
1. INSPECT CIRCUIT OPENING RELAY
Using an ohmmeter, measure the resistance
according to the value(s) in the table below.
Standard resistance
If the result is not as specified, replace the relay. ...
Horn
To sound the horn, press on or
close to the mark.
WARNINGCaution while driving
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an
accident,
resulting in death or serious injury.
After adjusting the steeri ...
