When a "Normal" code is output during a DTC check but the problem still occurs, use the Problem Symptoms Table. The suspected areas (circuits or parts) for each problem symptoms are in the table. The suspected areas are listed in order of probability. A description of each of the chart's columns is shown in the table below.
HINT:
In some cases, the problem is not detected by the diagnostic system even though a problem symptom occurs. It is possible that the problem is occurring outside the detection range of the diagnostic system, or that the problem occurs in a completely different system.
Item | Description |
Problem Symptom | - |
Circuit Inspection, Inspection Order | Indicates the order in which the circuits need to be checked |
Circuit or Part Name | Indicates the circuit or part which needs to be checked |
See Page | Indicates the page where the flowchart for each circuit is located |
Removing the second seats
Removing the second outside seats (Tip-up seats)
Pull the armrests up.
Pull the seatback adjustment
lever and fold down the seatback.
The cushion will tip up.
Slide the seat forward to a lock position.
Pull the release lever under
the cushion and simultaneously
lift the ...
Installation
1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Exhaust
Side)
Apply a light coat of engine oil to the new O-ring and
install it to the camshaft timing oil control valve.
Install the camshaft timing oil control valve
assembly with the bolt.
Torque: 10 N ...
Armrests
Pull the armrest down for use.
Front seat
Second seat (if equipped)
Adjusting the front seat armrests (if equipped)
Push the armrest down while pressing the
button.
NOTICE
To prevent damage to the armrest, do not apply too much load on the
armrest.
...