INSPECTION PROCEDURE
1 CHECK RADIO AND NAVIGATION ASSEMBLY
OK: The radio's automatic station search function works properly.
2 INSPECT RADIO AND NAVIGATION ASSEMBLY
Standard voltage
3 CHECK OPTIONAL COMPONENTS
OK: Optional components are installed.
NOTICE: Do not remove any optional components installed by the customer without his or her consent
4 CHECK RADIO AND NAVIGATION ASSEMBLY
OK: Noise occurs
5 CHECK GLASS ANTENNA
HINT: Check for continuity at the center of each antenna wire as shown in the illustration.
NOTICE: When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wrap a piece of tin foil around the tip of the negative probe and press the foil against the wire with your finger, as shown in the illustration.
OK: There is continuity in the antenna.
6 REPLACE ANTENNA AMPLIFIER
OK: The antenna amplifier operates normally
REPLACE RADIO AND NAVIGATION ASSEMBLY
Seat Belt Buckle Switch LH Circuit Malfunction
DTC B0126/27 Seat Belt Buckle Switch LH Circuit Malfunction
DESCRIPTION
The seat belt buckle switch LH circuit consists of the center airbag sensor
assembly and the front seat
inner belt assembly LH.
DTC B0126/27 is recorded when a malfunction is detected in the seat belt buckle
switch LH ...
Problem symptoms table
Vehicle stability control system:
TERMINALS OF ECU
1. Terminal of ECU
(*1): Models with dynamic laser cruise control
(*2): 2WD model
2. Terminal Inspection
(a) Disconnect the connector and measure the voltage or resistance on the wire harness side.
HINT: Voltage cannot be measured wit ...
Camshaft Position "A" - Timing Over-Advanced
DTC P0011 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 1)
DTC P0012 Camshaft Position "A" - Timing Over-Retarded
(Bank 1)
DTC P0021 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 2)
DTC P0022 Camshaft Position ...