Toyota Sienna Service Manual: Radio receiver

Television Display Power Source Circuit

DESCRIPTION This is the power source circuit to operate the television display assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT TELEVISION DISPLAY ASSEMBLY Disconnect the connec ...

Removal

1. REMOVE INSTRUMENT CLUSTER CENTER NO. 1 FINISH PANEL 2. REMOVE INSTRUMENT CLUSTER CENTER NO. 2 FINISH PANEL 3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH 4. REMOVE RADIO RECEIVER &nbs ...

Other materials:

Reassembly
1. INSTALL PLANETARY GEAR (a) Apply grease to the planetary gears and pin parts of the planetary shaft. (b) Install the 3 planetary gears. 2. INSTALL STARTER ARMATURE ASSEMBLY (a) Apply grease to the plate washer and the armature shaft. (b) Install the starter armature to the star ...

Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).  Install the center rear seat lap type belt assembly with the bolt. Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) 2. IN ...

Problem symptoms table
Before inspecting the suspected areas listed in the table below, check the fuse and relay.  Before inspecting the suspected areas listed in the table below, check the DTCs.  Methods used to verify the cause of the problem are listed in order of probability in the suspected are ...