DTC B1155/39 Rear Airbag Sensor LH Circuit Malfunction
DESCRIPTION
The rear airbag sensor LH circuit consists of the center airbag sensor assembly and rear airbag sensor LH.
If the center airbag sensor assembly receives signals from the rear airbag sensor LH, it judges whether or not the SRS should be activated.
DTC B1155/39 is recorded when a malfunction is detected in the rear airbag sensor LH circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK DTC
OK: DTC B1155/39 is not output.
HINT: Codes other than code B1155/39 may be output at this time, but they are not related to this check.
USE SIMULATION METHOD TO CHECK
2 CHECK CONNECTION OF CONNECTORS
OK: The connectors are connected.
3 CHECK FLOOR WIRE (OPEN)
NOTICE: Do not forcibly insert a service wire into the terminals of the connector when connecting.
Standard resistance
NOTICE: Do not forcibly insert a service wire into the terminals of the connector when connecting.
Standard resistance
4 CHECK FLOOR WIRE (SHORT TO B+)
Standard voltage
5 CHECK FLOOR WIRE (SHORT TO GROUND)
Standard resistance
6 CHECK FLOOR WIRE (SHORT)
Standard resistance
7 CHECK REAR AIRBAG SENSOR LH
Result
HINT: Codes other than DTC B1154/38 and B1155/39 may be output at this time, but they are not related to this check.
USE SIMULATION METHOD TO CHECK
Voice is not Recognized
INSPECTION PROCEDURE
1 CHECK NAVIGATION SETTINGS
Enter the "Menu" screen by pressing the "MENU" switch.
Select "Setup
Check that "Voice Recognition Guidance" is not OFF.
OK:
Voice Recognition Guidance is not OFF.
2 CHECK MAP DISC
...
Data list / active test
1. DATA LIST
HINT:
Using the intelligent tester's DATA LIST allows the status
of a switch, sensor, actuator and other items to be read
without removing any parts. Reading the DATA LIST
early in troubleshooting is one way to save time.
Connect the intelligent tester (with CAN VIM) to t ...
Room temperature sensor
On-vehicle inspection
1. INSPECT A/C ROOM TEMPERATURE SENSOR
(a) Remove the A/C room temperature sensor.
(b) Measure the resistance according to the value(s) in
the table below.
Standard resistance
NOTICE:
Even slightly touching the sensor may
change the resistance value. Be sure ...