Toyota Sienna Service Manual: Rear axle beam

Disposal

1. DISPOSE OF SHOCK ABSORBER ASSEMBLY REAR LH (a) Fully extend the shock absorber rod. (b) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside ...

Removal

1. Remove rear wheel 2. Remove skid control sensor wire (for 2wd) Hint: (see page sp-38) hint: disconnect the rh side by the same procedures as the lh side. 3. SEPARATE SPEED SENSOR REAR LH (fo ...

Other materials:

Installation
1. INSTALL REAR AXLE BEAM DAMPER (a) Install the rear axle beam damper to the rear axle beam assembly. 2. INSTALL REAR AXLE CARRIER BUSH LH (a) Align the matchmarks on the axle beam assembly with the 2 notches of a new bushing and temporarily install the bushing to the rear axle beam assem ...

Rear view monitor system precautions
Area displayed on screen The rear view monitor system displays an image of the view from the bumper of the rear area of the vehicle. The image on the rear view monitor system can be adjusted. The area displayed on the screen may vary according to vehicle orientation conditions. ...

For vehicles equipped with mobile communication systems
FOR VEHICLES EQUIPPED WITH MOBILE COMMUNICATION SYSTEMS (a) Install the antenna far away from the ECU and sensors of the vehicle electronic systems as possible. (b) Install an antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle electronic systems. For de ...