Toyota RAV4 manuals

Toyota Sienna Service Manual: Rear axle hub and bearing (for 4wd)

Toyota Sienna Service Manual / Axle / Rear axle hub and bearing (for 4wd)

COMPONENTS

Rear axle hub and bearing (for 4wd)

Installation
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH (a) Install the hub & Bearing assembly LH with the 4 bolts. Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf) 2. INSPECT BEARING BACKLASH (See page ...

On-vehicle inspection
1. INSPECT REAR AXLE HUB BEARING BACKLASH (a) Using a dial gauge, check for backlash near the center of the axle hub. Maximum: 0.05 mm (0.0020 in.) If backlash exceeds the maximum, replace th ...

Other materials:

Adjusting the set speed
To change the set speed, operate the lever until the desired set speed is displayed. Increases the speed Decreases the speed Fine adjustment: Momentarily move the lever in the desired direction. Large adjustment: Hold the lever in the desired direction. In the vehicle-to-vehicl ...

Removal
1. DISCHARGE FUEL SYSTEM PRESSURE 2. REMOVE V-BANK COVER SUB-ASSEMBLY 3. DRAIN ENGINE COOLANT 4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY 5. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY 6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY 7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 8. REMOVE INTAKE AIR SURGE TA ...

Power outlets
The power outlet can be used for the following components: 12 V: Accessories that run on less than 10 A 120 V AC: Accessories that use less than 100 W 12 V Open the cover. Center panel type A Center panel type B Luggage compartment 120 V AC (if equipped) Open the ...

В© 2011-2024 Copyright www.tsienna.net