Toyota Sienna 2010-2026 Owners Manual: Rear ceiling lights
Turns the lights on/off
When the personal/interior light main switch is in the off position, the rear ceiling lights will not turn on even if the switch is on.
Adjusting the rear personal/interior lights angle (if equipped)
Push the edge of the light lens.
Illuminated entry system
- Vehicles without a smart key system The lights automatically turn on/off according to the engine switch position, whether the doors are locked/ unlocked, and whether the doors are open/ closed.
- Vehicles with a smart key system The lights automatically turn on/off according to engine switch mode, the presence of the electronic key, whether the doors are locked/unlocked, and whether the doors are open/closed.
To prevent battery discharge
If the interior lights remain on when the engine switch is turned off, the lights will go off automatically after 20 minutes.
Customization
Settings (e.g. the time elapsed before lights turn off) can be changed.
| NOTICE Rear ceiling lights (if equipped) Do not hang anything on the gap between the ceiling light cover and the ceiling or pull the ceiling light cover strongly. Doing so may cause damage. |
Personal/interior
lights
Front
Turns the light on/off
Rear
Turns the light on/off
When the personal/interior light main switch is in the off position, the
rear personal lights will not turn on even if the switch is o ...
Other materials:
2Gr-fe engine mechanical
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE FUEL
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE EMISSION CONTROL
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE INTAKE
SERVICE DATA
TORQUE SPECIFICATIONS
2GR-FE EXHAUST
SERVICE DATA
TORQUE SPECIFICAT ...
Diagnosis system
1. DESCRIPTION
When troubleshooting a vehicle with the diagnosis
system, the only difference from the usual
troubleshooting procedure is connecting the intelligent
tester to the vehicle and reading various data output from
the vehicle's clearance warning ECU.
The clearance warning ECU record ...
Access monitor result
(A) select the following menus on the intelligent tester:
diagnosis, enhanced obdii, monitor info
and monitor result. The monitor status
appears after the component name.
INCMP: The component has not been monitored
yet.
PASS: The component is functioning normally.
FAIL: The component is ...
