Toyota Sienna Service Manual: Rear center seat outer belt assembly

Installation

1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).  Install the center ...

Removal

1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).  Remove the rear seatba ...

Other materials:

Removal
1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY 2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY 3. DRAIN ENGINE COOLANT 4. REMOVE V-BANK COVER SUB-ASSEMBLY 5. REMOVE NO. 2 AIR CLEANER INLET 6. REMOVE NO. 1 AIR CLEANER INLET 7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY 8. REMOVE AIR CLEANER CASE SUB-ASSE ...

Power Slide Door LH does not Operate When Using Inside / Outside Handle
DESCRIPTION  The inside / outside handles have the ability to control operation of the power slide door. Pulling either handle transmits a request signal to the power slide door ECU LH, which then commands the power slide door control motor and clutch to open / close the power sli ...

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...