Toyota RAV4 manuals

Toyota Sienna Service Manual: Rear Clearance Sonar Sensor LH Circuit

DESCRIPTION

An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT NO. 1 ULTRASONIC SENSOR

INSPECT NO. 1 ULTRASONIC SENSOR

  1. Remove the No. 1 ultrasonic sensor.
  2.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

2 CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR)

CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU

  1. Disconnect the C9 connector from the clearance warning ECU.

CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU

  1. Disconnect the U4 connector from the No. 1 ultrasonic sensor.
  2.  Measure the resistance according to the value(s) in the table below.

Standard resistance

Standard resistance

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Front Clearance Sonar Sensor RH Circuit
DESCRIPTION An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic wave ...

Rear Clearance Sonar Sensor RH Circuit
DESCRIPTION An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic wave ...

Other materials:

Power Back Door Warning Buzzer does not Sound
DESCRIPTION The power back door system uses a warning buzzer built into the back door, which has 3 ways of sounding that are used differently according to the situations: When all the following conditions are met, the warning buzzer sounds at a cycle of 0.3 seconds: * The ignitio ...

Window lock switch
Press the switch down to lock the passenger window switches. Use this switch to prevent children from accidentally opening or closing a passenger window. The power windows can be operated when The engine switch is in the “ON” position (vehicles without a smart key system) or IGNIT ...

Throttle / Pedal Position Sensor
HINT: These DTCs relate to the Accelerator Pedal Position (APP) sensor. DESCRIPTION HINT: This ETCS (Electronic Throttle Control System) does not use a throttle cable. The Accelerator Pedal Position (APP) sensor is integrated with the accelerator pedal bracket and has 2 sensor circuits ...

© 2011-2024 Copyright www.tsienna.net