Toyota Sienna Service Manual: Rear combination light assembly
COMPONENTS
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR COMBINATION LIGHT ASSEMBLY
- Remove the 2 bolts.
- Disengage the 2 pins and separate the rear combination light assembly as shown in the illustration.
- Disconnect the connector and remove the rear combination light assembly.
DISASSEMBLY
1. REMOVE REAR COMBINATION LIGHT BULB
- Turn in the direction indicated by the arrow and separate the 2 rear combination light bulbs.
- Remove the 2 rear combination light bulbs from the rear combination light socket and wire subassembly.
REASSEMBLY
1. INSTALL REAR COMBINATION LIGHT BULB
- Install the 2 rear combination light bulbs to the rear combination light socket and wire sub-assembly.
- Turn in the direction indicated by the arrow and install the 2 rear combination light bulbs to the rear combination light assembly.
INSTALLATION
1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
- Connect the connector.
- Install the rear combination light assembly with the 2
bolts and 2 pins as shown in the illustration.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Installation
1. INSTALL FOG LIGHT ASSEMBLY
Install the fog light assembly with the 2 claws and 2
pins.
2. INSTALL FRONT BUMPER ASSEMBLY
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
4. VEHICL ...
Back-up light assembly
COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
2. REMOVE BACK DOOR SIDE GARNISH LH
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR STRAP COVER SUBASSEMBLY
5. REMOVE BACK D ...
Other materials:
Short to B+ in Driver Side Squib 2nd Step Circuit
DTC B1183/22 Short to B+ in Driver Side Squib 2nd Step Circuit
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor
assembly, the spiral cable and
the steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1183/22 ...
Short in Side Squib RH Circuit
DTC B0110/43 Short in Side Squib RH Circuit
DESCRIPTION
The side squib RH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0110/43 is recorded when a short cir ...
Light Sensor Circuit Malfunction
DTC B1244 Light Sensor Circuit Malfunction
DESCRIPTION
This DTC is output when failure in the light sensor circuit is detected.
DTC No.
DTC Detection Condition
Trouble Area
B1244
Malfunction of automatic light control sensor
Open or short of a ...
