Toyota Sienna Service Manual: Rear differential side gear shaft bolt

Reassembly

1. INSTALL REAR DIFFERENTIAL PINION SHAFT (a) Install the 2 thrust washers to the 2 side gears. (b) Install the 2 side gears, 2 differential pinion gears, 2 differential pinion thrust washers ...

Removal

1. REMOVE REAR WHEEL 2. REMOVE EXHAUST PIPE ASSEMBLY HINT: Perform this procedure only when removing the RH side. (See page EX-8) 3. REMOVE REAR SPEED SENSOR LH HINT: (See page DS-21) 4. REM ...

Other materials:

Side Airbag Sensor Assembly RH Circuit Malfunction
DTC B1140/32 Side Airbag Sensor Assembly RH Circuit Malfunction DESCRIPTION The side airbag sensor RH circuit consists of the center airbag sensor assembly and side airbag sensor RH. If the center airbag sensor assembly receives signals from the side airbag sensor RH, it judges whether or ...

Repair
1. INTRODUCTION (a) This section introduces ways to determine whether the run-flat tire is repairable or not. Repair must be performed by following the appropriate procedures. If a flat tire occurs, it is possible to drive a maximum of 160 km (100 miles) at a speed below 90 km/h (55 mph) due ...

Short to GND in Curtain Shield Squib LH Circuit
DTC B1167/85 Short to GND in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1167/85 is ...