Toyota Sienna Service Manual: Rear disc brake

Installation

HINT: Install the RH side by the same procedure as the LH side. 1. INSTALL FRONT DISC BRAKE CYLINDER SLIDE BUSH (a) Apply the lithium soap base glycol grease to a new front disc brake cylinder ...

Removal

HINT: Remove the RH side by the same procedure as the LH side. 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID NOTICE: Wash the brake fluid off immediately if it attaches to any painted surface. 3. S ...

Other materials:

Removal
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (See page AC-172) 2. REMOVE FRONT WHEEL RH 3. REMOVE FRONT FENDER APRON SEAL RH (See page EM-26) 4. REMOVE V-RIBBED BELT (See page EM-6) 5. REMOVE RADIATOR AND FAN ASSEMBLY (See page CO-28) 6. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (a) Re ...

Disassembly
1. REMOVE BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY (a) Using soft jaws on the vise, hold the brake master cylinder in a vise through aluminum plates. (b) Using a screwdriver, remove the O-ring. (c) Using SST, remove the brake tube from the brake master cylinder. SST 09023 ...

Air Inlet Damper Position Sensor Circuit
DESCRIPTION This sensor detects the position of the air inlet control servo motor and sends the appropriate signals to the A/C amplifier. The position sensor is built in the air inlet control servo motor. The position sensor's resistance changes as the air inlet control servo motor ar ...