Toyota Sienna Service Manual: Rear door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
- Check that there is resistance between the terminal and the switch body when the switch is operated.
Resistance:
ON (When shaft is pressed):
10 kΩ or higher
OFF (When shaft is not pressed):
Below 1 Ω
Front door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH
ASSEMBLY
Check that there is resistance between the terminal
and the switch body when the switch is operated.
Resistance:
ON (When shaf ...
Back door courtesy switch
INSPECTION
1. BACK DOOR LOCK ASSEMBLY (WITH OUT POWER BACK DOOR)
Inspect back door courtesy light switch operation.
Check that there is resistance between the
terminal 5 a ...
Other materials:
On-vehicle inspection
1. INSPECT MASS AIR FLOW METE
NOTICE:
Perform the mass air flow (MAF) meter inspection
by following the procedures below.
Only replace the MAF meter when the MAF value
in the DATA LIST (with the engine stopped) are
not within the normal operating range or there is
fore ...
Reassembly
1. INSTALL PLANETARY GEAR
(a) Apply grease to the planetary gears and pin parts of
the planetary shaft.
(b) Install the 3 planetary gears.
2. INSTALL STARTER ARMATURE ASSEMBLY
(a) Apply grease to the plate washer and the armature
shaft.
(b) Install the starter armature to the star ...
Installation
1. INSTALL COMBINATION METER ASSEMBLY
Connect the connectors.
Install the combination meter assembly with the 4
screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Install the instrument cluster finish panel subassembly
with the 4 clips.
3. C ...
