DTC B1217 Rear Door ECU LH Communication Stop
DESCRIPTION
DTC B1217 is output when communication between the power slide door ECU LH and the multiplex network gateway ECU stops for more than 10 seconds.
DTC No. |
DTC Detection Condition |
Trouble Area |
B1217 |
RL-DOOR ECU communication stops |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - BATTERY)
Standard voltage
2 CHECK HARNESS AND CONNECTOR (POWER SLIDE DOOR ECU LH - GROUND)
Standard resistance
3 CHECK COMMUNICATION LINE
Standard resistance
Result
REPLACE POWER SLIDE DOOR ECU LH
Terminals of ECU
1. CHECK POWER SLIDE DOOR ECU LH (WITH
POWER SLIDE DOOR)
Disconnect the P25 and P26 ECU connectors, and
check the voltage and resistance of each terminal of
the wire harness side connectors.
If the result is not as specified, there may be a
malfunction on the wire harness side.
...
Short to GND in Side Squib LH Circuit
DTC B0117/45 Short to GND in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0117/45 is recorded when a s ...
Front Airbag Sensor RH Circuit Malfunction
DTC B1148/36 Front Airbag Sensor RH Circuit Malfunction
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor
assembly and front airbag sensor
RH. If the center airbag sensor assembly receives signals from the front airbag
sensor RH, it judges
whether or not the ...