Toyota Sienna Service Manual: Rear no. 1 Seat assembly (for Center Seat)

Installation

1. INSTALL REAR NO. 1 SEAT ASSEMBLY LH  Place the seat in the cabin. NOTICE: Be careful not to damage the body.  Install the seat.  7-Passenger RH: Install the seat belt ...

Components

REMOVAL 1. REMOVE REAR NO. 1 SEAT ASSEMBLY CENTER  Remove the headrest.  Remove the bolt and seat belt anchor plate.  Remove the rear seat. ...

Other materials:

Removal
1. Remove windshield wiper motor assembly hint: (see page ww-4) 2. Remove front outer cowl top panel subassembly (see page em-27) 3. Drain engine coolant (see page co-6) 4. Remove v-bank cover sub-assembly (see page em-28) 5. Remove no. 2 Air cleaner inlet (see page em- 28) 6. Remove no. 1 ...

Back Door ECU Communication Stop
DTC B1287 Back Door ECU Communication Stop DESCRIPTION DTC B1287 is output when communication between the power back door ECU and the multiplex network gateway ECU stops for more than 10 seconds. DTC No. DTC Detection Condition Trouble Area B1287 Back d ...

Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU Disconnect the G4 ECU connector. Measure the voltage between the specified terminals on the wire harness side connector. If the result is not as specified, there may be a malfunction on the wire harness side. Measure the resistance between ...