DTC B1787 Rear Occupant Classification Sensor LH Collision Detection
DESCRIPTION
DTC B1787 is output when the occupant classification ECU receives a collision detection signal sent by the rear occupant classification sensor LH if an accident occurs.
DTC B1787 is also output when the front seat assembly RH is subjected to a strong impact, even if an actual accident does not occur.
However, when the occupant classification ECU outputs a collision detection signal, even if the vehicle is not in a collision, DTC B1787 can be cleared by "Zero point calibration" and "Sensitivity check".
Therefore, if DTC B1787 is output, first perform "Zero point calibration" and "Sensitivity check".
WIRING DIAGRAM
INSPECTION PROCEDURE
1 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
2 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
3 CHECK DTC
OK: DTC B1787 is not output.
HINT: Codes other than DTC B1787 may be output at this time, but they are not related to this check.
4 REPLACE FRONT SEAT ASSEMBLY RH
HINT: Perform the inspection using parts from a normal vehicle if possible.
5 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
6 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
7 CHECK DTC
HINT: First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.
OK: DTC B1787 is not output.
HINT: Codes other than DTC B1787 may be output at this time, but they are not related to this check.
8 REPLACE OCCUPANT CLASSIFICATION ECU
9 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
10 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
END
Reassembly
1. INSTALL OVERDRIVE DIRECT CLUTCH O-RING
(a) Coat an O-ring with ATF, and install it to the direct
clutch drum.
NOTICE:
Make sure that the O-ring is not twisted or
pinched when it is installed.
2. INSTALL OVERDRIVE DIRECT CLUTCH DRUM SUBASSEMBLY
(a) Coat the direct clutch drum with A ...
Inspection
1. INSPECT TIRE PRESSURE WARNING RESET SWITCH
(a) Remove the tire pressure warning reset switch.
(b) Measure the resistance between terminals 1 and 2
of the tire pressure warning reset switch when the
tire pressure warning switch is ON and OFF.
Standard resistance
If the result is not as ...
Canceling the rear moon roof operation (vehicles with the rear
moon roof)
Press the switch to disable the
rear moon roof operation from the
rear seat.
Pressing the switch again will
enable the operation again.
The moon roof can be operated when
The engine switch is in the “ON” position (vehicles without a smart key
system)
or IGNITION ON mode (vehicles ...