DTC B1788 Rear Occupant Classification Sensor RH Collision Detection
DESCRIPTION
DTC B1788 is output when the occupant classification ECU receives a collision detection signal sent by the rear occupant classification sensor RH if an accident occurs.
DTC B1788 is also output when the front seat assembly RH is subjected to a strong impact, even if an actual accident does not occur.
However, when the occupant classification ECU outputs a collision detection signal, even if the vehicle is not in a collision, DTC B1788 can be cleared by "Zero point calibration" and "Sensitivity check".
Therefore, if DTC B1788 is output, first perform "Zero point calibration" and "Sensitivity check".
DTC No. |
DTC Detection Condition |
Trouble Area |
B1788 |
|
|
INSPECTION PROCEDURE
1 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed
2 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
3 CHECK DTC
OK: DTC B1788 is not output. HINT: Codes other than DTC B1788 may be output at this time, but they are not related to this check.
4 REPLACE FRONT SEAT ASSEMBLY RH
HINT: Perform the inspection using parts from a normal vehicle if possible.
5 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
6 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
7 CHECK DTC
HINT: First clear DTCs stored in the occupant classification ECU and then in the center airbag sensor assembly.
OK: DTC B1788 is not output. HINT: Codes other than DTC B1788 may be output at this time, but they are not related to this check.
8 REPLACE OCCUPANT CLASSIFICATION ECU
9 PERFORM ZERO POINT CALIBRATION
OK: "COMPLETED" is displayed.
10 PERFORM SENSITIVITY CHECK
Standard value: 27 to 33 kg (59.52 to 72.75 lb)
END
Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DTC B2223 Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DESCRIPTION
A pulse sensor is built into slide door RH for jam and foreign
object detection and for slide door position
detection. The jam and foreign object detection feature of the pulse sensor
monitors the ...
Camshaft Position "A" - Timing Over-Advanced
DTC P0011 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 1)
DTC P0012 Camshaft Position "A" - Timing Over-Retarded
(Bank 1)
DTC P0021 Camshaft Position "A" - Timing Over-Advanced
or System Performance (Bank 2)
DTC P0022 Camshaft Position ...
Removal
1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
HINT:
(See page EX-8)
2. REMOVE PROPELLER WITH CENTER BEARING
SHAFT ASSEMBLY
HINT:
(See page PR-3)
3. REMOVE REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (10 mm), remove the filler
plug and gasket.
4. REMOVE REAR DIFFERENTIAL DRAIN PLUG
(a ...