Toyota RAV4 manuals

Toyota Sienna Service Manual: Rear Power Seat Switch Circuit

DESCRIPTION

When the power rear no. 2 seat switch is operated, a recline signal is sent to the fold seat control ECU.

The ECU activates the reclining motor based on the signal from the power rear no. 2 seat switch.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT FOLD SEAT CONTROL ECU

INSPECT FOLD SEAT CONTROL ECU

  1. Remove the fold seat control ECU.
  2.  Measure the voltage according to the value(s) in the table below.

Standard voltage: LH side

Standard voltage

RH side

Standard voltage

2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)

CHECK HARNESS AND CONNECTOR

  1. Disconnect the connectors from the fold seat control ECU.
  2.  Disconnect the connector from the folding motor.
  3. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance

3 INSPECT POWER REAR NO. 2 SEAT SWITCH

INSPECT POWER REAR NO. 2 SEAT SWITCH

  1. Disconnect the connector from the power rear no. 2 seat switch.
  2. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance

4 CHECK HARNESS AND CONNECTOR (FOLDING MOTOR - BODY GROUND)

CHECK HARNESS AND CONNECTOR

  1. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance

5 REPAIR OR REPLACE HARNESS OR CONNECTOR (WIRE INSIDE SEAT)

  1. Repair or replace harness or connector (wire inside seat) and check that the malfunction disappears.

OK: Malfunction disappears.

END

Lock Switch Circuit
DESCRIPTION Each of the left and right seats has lock switches that detect the lock condition of the seat legs to the floor when the seat is in the original or folded-down state. If any of the loc ...

Fold Lock Switch Circuit
DESCRIPTION Each of the left and right seats has a fold lock switch that detects the lock condition of the seat legs and floor when the seat is in the stowed state. If the fold lock switch detects ...

Other materials:

Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/ Table)  Using a screwdriver, disengage the claws and remove the seat side table leg cover. HINT: Tape the screwdriver tip before use. 2. REMOVE FRONT SEAT SIDE TABLE (w/ Table)  Remove the 4 nuts and seat side table.  Rem ...

Grocery bag hooks
The hooks are designed to hang things like a grocery bag. Type A (front seatback) (if equipped) Type B (third seatback) Type C (luggage compartment) Type D (luggage compartment) Pull the hook up. WARNING Type C: When not in use, keep the grocery ...

Front passenger occupant classification system
Your vehicle is equipped with a front passenger occupant classification system. This system detects the conditions of the front passenger seat and activates or deactivates the devices for the front passenger. SRS warning light Seat belt reminder light “AIR BAG OFF” indicator light ...

© 2011-2024 Copyright www.tsienna.net