Toyota Sienna Service Manual: Rear seat inner belt assembly

Disposal

1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN INSTALLED IN VEHICLE) NOTICE:  Never dispose of a front seat outer belt assembly with an deactivated pretensioner.  The seat belt ...

Removal

1. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).  Remove the bolt and re ...

Other materials:

Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System) (See page PM-19) 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System) (See page PM-19) 3. REMOVE REAR BUMPER ENERGY ABSORBER 4. REMOVE REAR BUMPER BAR PLATE Remove the 4 clips and the rear bumper bar plate. 5. ...

How to proceed with troubleshooting
HINT:  Use this procedure to troubleshoot the front power seat control system.  The intelligent tester should be used in steps 3 and 5. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS CHECK AND PROBLEM SYMPTOM CHECK 3 CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNI ...

Power slide door touch sensor
INSPECTION 1. INSPECT POWER SLIDE DOOR TOUCH SENSOR LH Check the resistance of the sensor. Resistance If the result is not as specified, replace the sensor. 2. INSPECT POWER SLIDE DOOR TOUCH SENSOR RH Check the resistance of the sensor. Resistance If the result is not a ...