COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT REAR SPEAKER
HINT: Remove interior parts so that the rear speaker can be seen.
OK: The speaker is securely installed.
If the result is not as specified, reinstall the rear speaker.
OK: The cone paper of the speaker is not torn.
If the result is not as specified, replace the rear speaker.
Standard resistance:
6 Speaker system:
Approximately 4 Ω
10 Speaker system:
Approximately 2.4 Ω
If the result is not as specified, replace the rear speaker.
REMOVAL
1. REMOVE REAR DOOR SCUFF PLATE
2. REMOVE REAR DOOR WEATHERSTRIP
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY
6. REMOVE REAR SPEAKER ASSEMBLY
INSTALLATION
1. INSTALL REAR SPEAKER ASSEMBLY
NOTICE: Tighten the screws in order shown in the illustration to install the rear speaker assembly.
2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY
3. INSTALL BACK DOOR SCUFF PLATE
4. INSTALL BACK DOOR WEATHERSTRIP
5. INSTALL REAR DOOR WEATHERSTRIP
6. INSTALL REAR DOOR SCUFF PLATE
Data list / active test
1. DATA LIST
HINT:
By the DATA LIST displayed by the intelligent tester, you
can read the value of the switch, sensor, actuator and so
on without removing any part. Reading the DATA LIST
as the first step in troubleshooting is one of the methods
to shorten the labor time.
Connect the ...
Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles
up to approximately 400 ft. (120 m) ahead, determines the current
vehicle-to-vehicle following distance, and operates to maintain a suitable
following distance from the vehicle ahead.
Note that vehicle-to-vehicle distance will ...
Fuel Pump Primary Circuit
DTC P0230 Fuel Pump Primary Circuit
DESCRIPTION
This DTC is designed to detect a malfunction in the fuel pump
(FUEL PUMP) relay circuit. When the
system is normal, the battery voltage is applied to FPR terminal of the ECM
while the FUEL PUMP
relay is turned OFF. If the battery v ...